Oldcastle Driveway & Pavers Nationwide

Oldcastle Driveway & Pavers: The Fort Worth Owner’s Guide

We stock and install Oldcastle-compatible driveway pavers and retaining wall units across Fort Worth, with most paver driveway repairs running $700 – $3,500 depending on the failed section and whether the base layer needs rebuilding. This page covers what fails first, what a proper fix costs, and how to tell if your Oldcastle paver issue is a simple swap or a deeper base problem. Most Fort Worth owners discover a problem the day a paver sinks, cracks, or shifts out of line, usually after a heavy rain cycle or a season of clay-soil movement.

Call (682) 841-6652

Key takeaways:

• Oldcastle pavers are modular and replaceable – you rarely need to redo the whole driveway.
• Fort Worth’s expansive clay soil is the #1 cause of paver failure we see, not the paver itself.
• Most paver repairs are done in a day; full paver driveway replacement runs $7,000 – $18,000.
• We are an independent Oldcastle-compatible service provider, not a factory branch.

Signs Your Oldcastle Driveway & Pavers Is Failing

• Sinking or cupped pavers near the driveway edges. Fort Worth’s clay soil expands when wet and shrinks when dry, and that cycle pushes the sand base out from under the outer rows first. If the edge pavers are dropping an inch or more, the base is migrating and the problem will spread inward.
• Widespread low spots that hold puddles after rain. Standing water means the base layer has settled unevenly. Oldcastle pavers themselves don’t hold water – the failure is underneath them. Left alone, puddled water undermines the next section over.
• Loose or wobbling pavers in a high-traffic path. When a paver rocks underfoot or under tire pressure, the joint sand has washed out and the locking friction is gone. This is repairable, but every freeze-thaw cycle in a Fort Worth winter makes it worse.
• Crumbling paver edges or corner spalling. This is usually a paver-level defect or freeze damage from trapped water, not a base failure. Individual units can be pulled and replaced if you caught it before the damage spread to the neighbors.
• Gaps widening between pavers in a straight line. A line of widening joints often signals a root pushing up from a nearby tree or a drainage channel forming underneath. The fix is never just sanding the joint – the cause has to come out first.

Replacement Cost & What’s Included

Paver driveway repair in Fort Worth runs about $700 – $3,500 for a typical failed section, depending on square footage, paver type, and whether we’re rebuilding the base or just swapping surface units. A full paver driveway installation runs $7,000 – $18,000. If the project is a patch job on an existing driveway, the smaller number is usually accurate. If the base has failed under half the driveway, you’re into the middle of that range. We write the price before work starts, broken into parts and labor, and the number on the invoice is the number you approved – no change orders, no end-of-job surprises. Every repair carries our 365-Day Done Right Promise: if it’s not done right, we make it right, in writing, on every job.

DIY or Call Us?

You can safely do a few things before calling: mark the sunken or cracked sections with chalk so you know the full scope, check whether the paver underside has a mold code, and note where water pools after a rain. What you shouldn’t DIY is pulling pavers without understanding what’s underneath. If the base has failed, you’ll spend a weekend, buy the wrong paver, and the repair will fail again in six months. Paver work looks simple and isn’t – a proper repair means compacting the base in lifts, re-screeding sand to grade, and matching the existing pattern and color. That’s why we do it in a day and guarantee it for a year. Call (682) 841-6652 and we’ll walk the driveway with you and tell you straight what it needs.