Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Therma-Tru Fence Installation: The Fort Worth Owner’s Guide
Therma-Tru fence installation in Fort Worth typically runs $3,500 to $9,000 installed, depending on linear footage, gate hardware, and whether we’re replacing an existing fence or starting fresh. We stock Therma-Tru-compatible fence panels and gate hardware on our trucks, and most installations wrap up in one to three days. What we see most often is a homeowner calling after a windstorm ripped a gate off its hinges, or after noticing the bottom rail has rotted out where it meets the Fort Worth clay soil. The product itself is solid. The failure usually comes from how it was installed the first time.
If you’re reading this holding a broken gate latch or staring at a leaning panel, you’re in the right place. We’ll walk through what fails, what it costs, and how to know if you need a repair or a full replacement.
Which Therma-Tru Models This Applies To
Therma-Tru is better known for entry doors, but their fence and gate product line carries through the same build philosophy: fiberglass and composite materials, not vinyl that turns brittle under the Fort Worth sun. The fence systems run in a few series lines, and compatibility matters more than most homeowners expect. A gate hinge kit for one series won’t drop onto another without shimming, and shims on a gate that swings 50 times a week is a repair waiting to happen.
Before we order parts, we check the panel stamp or the label on the hinge mortise. If the label’s faded, we measure the panel thickness and the rail profile. Therma-Tru fence panels run either a 1-3/4-inch or 2-inch rail width, and post sleeves differ between the gate and line posts. Aftermarket parts that claim to fit “all Therma-Tru models” are the fastest way to get a gate that sags in six weeks. We use OEM hardware for the hinge and latch assembly, and we’re picky about post depth because Fort Worth’s shifting clay will move a shallow post out of plumb within two seasons.
One more thing worth knowing: Sawyer Remodel Fort Worth is an independent service provider. We’re not affiliated with Therma-Tru, and we don’t pretend to be. We just install their fence systems correctly, and we fix the ones that weren’t.
Styles & brands we work with
Signs Your Therma-Tru Fence Installation Is Failing
- The gate drags or won’t latch. Hinge wear or post movement is the usual culprit. Fort Worth’s clay expands and contracts with moisture, and a post set too shallow leans within a year. The latch stops aligning, and the gate starts scraping the ground.
- Panels lean more than an inch off plumb. That’s a post failure, not a panel failure. A properly set post in North Texas needs to go below the frost line and into stable soil, which on our clay usually means a post hole closer to three feet than two.
- Bottom rails are soft, cracked, or splitting. Standing water at the base of a fence is the enemy. Fort Worth gets more than 35 inches of rain most years, and a bottom rail sitting in damp soil, even composite, will degrade. Proper clearance and drainage matter.
- You hear creaking or groaning in high wind. That’s panels working against the fasteners. Over time, the hardware loosens, and a good gust takes the panel with it. If your fence sounds like an old door in a storm, the fasteners are telling you something.
- Rust staining from the hardware. Therma-Tru hardware is coated, but the coating fails eventually, especially with the humidity swings we get in Fort Worth. Once the rust starts, the hardware seizes, and the gate gets harder to open with every passing month.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
For Fort Worth homeowners, Therma-Tru fence installation runs $3,500 to $9,000 on average. The spread comes down to three things: linear footage, whether you’re replacing posts or reusing them, and gate complexity. A simple 50-foot run with one gate lands at the lower end. A full backyard enclosure with two gates, rot-board replacement, and old fence disposal pushes toward the top.
| Scope | Typical Range |
|---|---|
| Gate replacement only (hinges, latch, hardware) | $350 – $900 |
| Section repair (1 – 3 panels, existing posts) | $900 – $2,500 |
| Full fence install (50 – 75 linear feet, one gate) | $3,500 – $5,500 |
| Full fence install (75 – 150 linear feet, two gates, disposal) | $5,500 – $9,000 |
Every quote is a written line-item price before any work starts. That’s the deal at Sawyer Remodel Fort Worth, and it goes back to how Luca Romano runs the company: the price you approve is the price you pay. No change orders halfway through because we “found something.” We do the walkthrough, we measure, we show you the number, and then we build. The installation carries our 365-Day Done Right Promise. If it’s not right, we make it right. In writing.
DIY or Call Us?
There are a few things you can safely check yourself. Walk the fence line and look for posts that wobble when you push on them. Lift the gate and feel for play in the hinges. Check that the latch catches fully and clean out any dirt packed around the bottom rail. Those are diagnostics we’d tell any owner to run.
What we’d tell you not to do is dig out and reset a post yourself without knowing what’s underground. Fort Worth has buried utilities all over the place, and a shallow post hole is how you end up paying twice. Pulling a gate into alignment with washers and muscle works for about a week. If the post is leaning, shimming the hinge buys time; it doesn’t fix the post. Fence work looks simple until you’re 40 inches deep in sticky clay with a post that won’t hold level. That’s the moment to call us at (682) 841-6652 and get a real estimate.
FAQs
With proper installation and post depth, a Therma-Tru fence in this climate lasts 15 to 20 years. The panels hold up to UV exposure and humidity well. What shortens the lifespan is shallow posts in shifting clay and bottom rails sitting in standing water. Call (682) 841-6652 and we’ll tell you what your existing fence has left in it.
Yes, in most cases a failing panel or gate is repairable without replacing the whole run. If the posts are sound, we can swap panels, hang a new gate, or reface the hardware for a fraction of full replacement cost. The exception is when multiple posts have shifted. At that point, we’re honest about it: you can chase repairs for years or fix the root cause once.
Most Therma-Tru fence installations in Fort Worth take one to three days, including gate hanging and old fence disposal. A gate-only replacement usually finishes the same day. Weather here is unpredictable in spring, so we build in a day of buffer on the schedule when the forecast looks rough.
We stock common Therma-Tru gate hinges, latches, panel hardware, and post kits on the truck, so most repairs don’t wait on a parts order. For unusual series or custom gate sizes, we order OEM parts and schedule the install the day they arrive. Call (682) 841-6652 with your fence details and we’ll tell you if it’s a same-week job.
The work talks. We just back it up.
Written by Luca Romano, Owner & Lead Remodeler, Sawyer Remodel Fort Worth at Sawyer Remodel Fort Worth, serving Fort Worth and nearby areas.
